The battery in vehicles serves to provide electric current, stabilize voltage, and back up alternators. This component is very important for the vehicle.
If the battery is in bad condition and often runs short, it is certain that the condition of your car battery is not suitable for use.
To maintain the condition of the battery in order to stay in top condition, it is better to carry out regular maintenance. Always maintain cleanliness, check the status of the battery water level, check for leaks, and so on.
In addition, the battery must also be kept away from flames for safety such as matches and smoking. Because the battery contains hydrogen which is explosive. Keep the battery out of reach of children because the components of the battery are made of hazardous chemicals.
It is better to use protective glasses when installing the battery. Because splashing battery water is very dangerous. Be careful with zuur battery fluid, because it can damage the skin and blind the eyes.
In order for the battery to live long according to its ability, taking care of the battery is an absolute thing. In conventional batteries, water is volatile. This requires you to add water to the battery periodically.
To keep it functioning optimally, you can listen to the following tips .
1. Turn off the Electrical System
When you heat the car, it's best not to turn on the air conditioner (AC) or other electronic devices. Because the condition of the battery is not fully charged with electricity . Heat for about five minutes to ten minutes so that the battery is completely ready to supply the electrical system.
Then after driving, don't forget to turn off all electrical components before the engine is turned off. The goal, so that the electricity in the battery is not reduced. This will make it easier for you to start the engine again.
2. Check Battery Fluid Level
Diligently check the battery water level. Checking the battery level is important. Battery water should not be below the minimum level or low level. Filling water should not exceed the upper level. Because, when the battery is hot, water can be sprayed out along with very corrosive steam. However, if the water level is below the amount, add enough. The addition of battery water is recommended to use pure battery water, not zuur battery water. Of course so that the cell is not damaged quickly.
3. Pay Attention to Cleanliness
Pay attention to the cleanliness of the battery surface on the negative and positive poles. When the battery terminals are dirty, the electric current cannot flow perfectly. As a result, the electricity supply is less. Gradually damage the terminal and can spread to electronic devices.
If you see greenish scale and dirt on the battery terminals, clean it immediately. The trick can use hot water to taste, then brush it clean. After cleaning, tighten the battery clamp bolt. Make sure the battery is always in a fixed position and does not shift. Batteries are easy to shake when the vehicle is moving, can be damaged quickly.
4. Battery Power Check
You can check the battery capacity with a tester. Or you can take it to a battery specialist. Check the power and make sure the battery is able to work properly. Because, a battery that lacks power can affect the car's electrical system. The most important thing is that the power supply to the car's brain (ECU) runs smoothly.
In terms of maintenance, the easiest is the MF battery. The power indicator is clear. There are green and red colors. Check, if the indicator is red, it means it must be replaced immediately. Conversely, if it is green, it means the battery is still worth using.
5. Check for Battery Leaks
Check if there is a leak in the battery. This can happen to the body of the battery or the cover. If a leak occurs and is not immediately addressed, corrosive water can damage the body and even other components.
Leaks in the body of the battery must be immediately replaced with a new one. If the leak only occurs in the battery cover, it can be tightened or a new battery cover can be replaced.
6. Battery Installation
Well, this seems easy, but rarely noticed. If you want to open the battery, first remove the hook on the negative pole, then remove the positive hook. On the other hand, when installing, put the positive and negative poles first. The goal is to avoid a short circuit.
0 Comments
Post a Comment